handling of floating configuration

[pdm]

1) add a window to Views
2) set 'floating' to true

note that you can switch to code view and the window is still drawn, you can't select the flyout any more.

Even worse if you also select modal: true.

[pdm]

hmm, i can't reproduce the modal problem all the time, but one time it drew the opaque stuff over Designer.

I can, however, close the window, which doesn't seem very helpful

[aconran]

Thanks for the report, we need to do some work re: floating on all components, not just window.

[cweirich]

Maybe related to this, when I set the floating property of any component to true, it just disappears from the design window.

When previewing it works fine.

[pdm]

I still have the same issue as @cweirich in Architect 2.1.0 build 637

[aconran]

Did you set a x and y coordinate? height/width?

[pdm]

I have set height/width but I don't see that there is x, y or position config properties on a floating panel/formpanel.

[Nxs]

Set to your floating component :

autoRender property to true
autoShow property to true
to see your floating component in Design Tab of SA (build 640) because by default it seems that floating components are not shown..