Sencha Architect Forums /
Sencha Architect 2.x: Help & Discussions /
Cannot configure Sencha cmd
The new Architect v2.1 looks nice, but I just cannot pass the setup stage.
I downloded Sencha Cmd and install it. After I open the Sencha Cmd Setup it asks to "Set the Sencha Cmd Path", I cannot get it to work properly. Never puts the green dot.
I tried to put the path, just parts of the path and the path+sencha. Nothings works.
Also, the Setup project with Cmd has the same problem. Tried to brose the Sencha Touch 2.1 and simply does nothing.
What am I doing wrong. Any advice?
Sencha Architect 2.1.0 Build 670 on OS X 10.7.5
Thanks in advanced.
What path are you giving it?
Hi Phil, thanks for your response.
I have tried all of them (allow me to explain):
I installed Sencha Cmd in:
The installation put secnha in:
I have tried all the paths (shown only the one where sencha is exactly at):
Also tried all of them with slash at the end and sencha at the end.
I am using:
Sencha Architect Version 2.1.0 Build 676 on OS X 10.7.5
In this new build, when I press Verify, nothing happens. The only time that displays a window is when I leave the path empty:
I have the same problem when defining the framework:
After browsing and selecting the path of the framework installation, it does nothing.
So, I have no idea what else to do.
Thanks in advance.
Try not installing it in webserver. /Users/philstrong/bin/Sencha/Cmd/3.0.500/
Or close to that
im having the same problem. Same architect, and cmd 184.108.40.206. Just cant save it!
Its in /Users/[username]/bin/Sencha/Cmd/220.127.116.11
What can this be ?